Creality Ender 3 V2 with ton of upgrades for visuals and stability:

- Closed cabinet with smart WiFi RGB (also remote controlled) LEDs and smart smoke detection sensor as well as 3D printed diy drawers.
- Dual Z axis for stable gantry movement. Two Z rods are timed, so they are never out of sync. It works perfectly, 0 problems in 2 years.
- Dual gear redrex extruder. Prints flexible filaments like TPU with ease.
- Magnetic two sided PEI bed. Perfect for ease of use and adhesion.
- Capricorn XS PTFE teflon tube for higher temperature resistance and smooth filament flow (not in the photos, I installed this after photos)
- CR touch auto bed leveling
- Upgraded firmware - easy automated bed leveling, auto bed mesh, filament load / unload, filament runout sensor settings, custom auto heat settings and a lot of others.
- Upgraded bed springs
- Filament runout detection sensor.
- Upgraded z axis coupler
- more than 30 spare nozzles (different sizes) and all original parts.

And others which I possibly have forgotten. I use an old android phone with Octoprint to control it completely removely, over internet. You can use a similar setup, or a respberry pi instead of a phone or use it completely offline, with sd card.

I have had the printer for over 2 years and I only use it when I need to repair anything around the house. So it has not been used a lot. I'm selling it because I decided to upgrade to a better device.

Note: anycubic resin printer and sunlu filament dryer in the photo, on the top of the cabinet are not for sale.